|
P.C.I.T. Installation Requirements **PCIT REQUIREMENTS**
1) There must be two outlets, a quad, on a DEDICATED CIRCUIT WITH AN ORANGE GROUND (ISOLATED GROUND) . They need to be located on the wall behind the equipment cabinet location. ADDITIONALLY TWO 3/4" CONDUITS STUBBED ABOVE THE CEILING, ONE FOR THE CAMERA ENCLOSURE AND ONE FOR THE EQUIPMENT CABINET ARE NEEDED. Please contact us for additional assistance. 2)When the electrical is being installed, the Following Conduit should also be installed. For Drop Ceiling: A 4S (low voltage box) next to the electrical box is to be installed with (1) 1/2"pipe from the box to a workable point above the ceiling tiles. Also (1) 3/4"pipe from the 4S box to the camera location and terminated into another box at 48" above the floor and within 16" of the corner of the wall. If a solid ceiling exists all of the above must be installed plus (2) single gang boxes are to be installed in the ceiling connected by ½" conduit ( location to be determined) leading to the 4S (low voltage box) in the wall. If none of this is possible, then surface mount conduit will need to be installed. This will be an additional parts and labor charge 3) A cabinet is needed with the following specifications. It will be 30 inches wide, 21 inches deep and 37 inches high, with 3 shelves and front doors. A counter top 48 inches long for writing and mounting the monitor will be on top. This should be located under or next to the one way window. THIS CABINET IS A MUST! 4) The one way mirror should have good reflective properties. The bottom of the window MOLDING must be above the counter height of 37 inches. 5) NOTE: The room must be clean and ready for installation, and the above mentioned preparations done in both the observation and therapy rooms before the electronic equipment installation is begun. The rooms must also be completely available during installation. If this cannot be accommodated, additional labor charges will be added to the invoice! Please be ready.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------- PCIT SUGGESTIONS 1) It is very important to have a clear design plan in place before you begin. SSL can assist you in all aspects of PCIT, lighting, electrical, cabinetry, work table, and more. Please feel free to contact us at anytime. 2) The rooms that will be utilized must be large enough to accommodate people and furniture comfortably. They must be clean and ready for installation before the installation crew arrives! 3) If the room has outside windows; blinds or curtains need to be installed on each opening to control outside lighting. No light should come into the room when it is in use. 4) Good lighting is a must. We suggest using incandescent track lighting that is controlled by a dimmer switch. This is the best type to insure good quality pictures and a warm room atmosphere. 5) It is very important to be careful what type of furniture is near the floor mounted camera enclosure. We want to negate the possibility of children tampering and climbing on the enclosure. SAFETY IS A NECESSITY! 6) NOTE: The room must be clean and ready for installation, and the above mentioned preparations done in both the observation and therapy rooms before the electronic equipment installation is begun. The rooms must also be completely available during installation. If this cannot be accommodated, additional labor charges will be added to the invoice! Please be ready. We are here to assist you in every phase of your PCIT installation. Please do not hesitate to contact us if you need help in any of these areas. We can provide cabinets, camera enclosures, and DVD if you desire.
|
||
| ||
